Tecsis — Limit Switch Electronics: Digital , Accuracy 0,2 % EGS80
Наличие
Цена
Для уточнения цены нам необходимо связаться с производителем. Отправляйте запрос по почте, через корзину сайта или через форму заявки.
Ответим на Ваш запрос в течение 5 дней.
Доставка
- транспортной компанией на Ваш выбор
- самовывоз из офиса в Санкт-Петербурге
- бесплатная доставка до терминала “Деловые Линии” в Санкт-Петербурге
The limit switch EGS80 allows to control 2 limit values via 2 relays. Connectable are force transducers and load cells with 0/4...20 mA output signal. The housing is prepared for top hat rail mounting.
Features
- Digital limit switch with LCD-Display and for DIN-Rail mounting
- For force transducer with 0/4...20mA output 2- and 3-wire
- 2 potential free relay contacts (changer) with status LED
- Freely programmable analog output (0-20 mA)
- Can be programmed via control panel or computer
- Free PC-software to set parameters via RS-232 interface
- Accuracy 0,2 % of the full scale
- Sensor supply 24 VDC, max. 70 mA
- Needed supply energy 20...90 VDC or 48...253 VAC
- Cable break connection
- User friendly and easy to maintain because of pluggable screw type terminals
- Compact design
- Protection Class IP 20
Application
In combination with load cells or force transducers the limit switch EGS80 is utilized in weighing and load control in hoisting devices, cranes and more. Connectable are 2- and 3- wire sensors as well as active sources with 0/4...20 mA-signal. The input monitors cable breaks and short-circuits on the line and the internal sensor supply is 24 VDC with max 70 mA. The outputs are 2 relays, an active 0/4...20 mA power output and a RS-232-interface. The power output is adjustable freely. The measured values are shown on a small LCD display, it is possible to choose between 17 units such as kg, t, N, bar, and so on. Usually the switch is not pre-adjusted and the customer connects it to the force transducer and also adjusts it. Operating and setting parameters is done through the control panel at the front or with help of the free computer program. The software can also be used to create a data file of the parameters. The file can be saved and installed in any EGS80 limit switch. This is very time saving in case that several switches need to be adjusted. Cables with "SUB-D9/25 to TRS connector" or "USB to TRS connector" are available. Those allow to connect the switch to a computer.
Техническая спецификация ae987.pdf Инструкция по использованию be987.pdf Software Operating instruction be987__sw.pdf Software EGS80 2007_software_egs80.zip USB Driver EGS80 USB-Treiber.zip
О компании Tecsis
Как производитель датчиков и измерительных приборов компания присутствует на рынке уже несколько десятилетий. К 1997г. она вышла на мировой рынок под эгидой бренда VDO, но уже в 2001 отделилась под собственным именем Tecsis.
Читать далее...