1-phase, 24 V DC (for S7-1500 and ET200MP) Siemens

Обзор



The design and functionality of the SIMATIC PM 1507 single-phase load power supply (PM = power module) with automatic range selection of the input voltage makes it an optimal match to the SIMATIC S7-1500 PLC. It supplies the S7-1500 system components such as CPU, system power supply (PS), I/O circuits of the input and output modules and, if necessary, the sensors and actuators with 24 V DC.

Дизайн


  • The load current supplies are directly fastened to the S7-1500 mounting rail (without connection to the backplane bus) and can be mounted directly to the left of the CPU (no installation clearance required)
  • Diagnostics LEDs to indicate status and faults: Operation, Fault, Stand-by
  • ON/OFF switches (operation/stand-by) in case of swapping modules
  • Mains connection plug with touch protection and strain relief for connection of input voltage (enables permanent wiring)
  • Plug-in 24 V DC output terminal with reverse polarity protection for connection of 24 V loads (enables permanent wiring)

Функции


  • Connection to all 1-phase 50/60 Hz networks (120 / 230 V AC) through automatic range switching
  • Short-term mains buffering
  • Output voltage of 24 V DC that is limited to maximum 28 V DC (prevents any damages in 24 V loads if input voltage is too high)
  • 50% "Extra Power" for 5 seconds per minute for short-term overloads, for example, when switching on 24V consumers
  • Parallel connection of two load current supplies for enhanced performance

Технические данные



Order number

6EP1332-4BA00

6EP1333-4BA00

Product

S7-1500 PM1507

S7-1500 PM1507

Power supply, type

24 V/3 A

24 V/8 A

Input

 

 

Input

1-phase AC

1-phase AC

Supply voltage

 

 

  • ● 1 with AC Rated value

120 V

120 V

  • ● 2 with AC Rated value

230 V

230 V

  • ● Note

Automatic range selection

Automatic range selection

Input voltage

 

 

  • ● 1 with AC

85 ... 132 V

85 ... 132 V

  • ● 2 with AC

170 ... 264 V

170 ... 264 V

Wide-range input

No

No

Overvoltage resistance

2.3 × Vin rated, 1.3 ms

2.3 × Vin rated, 1.3 ms

Mains buffering at Iout rated, min.

20 ms; at Vin = 93/187 V

20 ms; at Vin = 93/187 V

Rated line frequency

50 ... 60 Hz

50 ... 60 Hz

Rated line range

45 ... 65 Hz

45 ... 65 Hz

Input current

 

 

  • ● at rated input voltage 120 V

1.4 A

3.7 A

  • ● at rated input voltage 230 V

0.8 A

1.7 A

Switch-on current limiting (+25 °C), max.

23 A

62 A

Duration of inrush current limiting at 25 °C

 

 

  • ● maximum

3 ms

3 ms

I²t, max.

1.3 A²·s

12 A²·s

Built-in incoming fuse

T 3,15 A/250 V (not accessible)

T 6.3 A/250 V (not accessible)

Protection in the mains power input (IEC 898)

Recommended miniature circuit breaker: 10 A characteristic B or 6 A characteristic C

Recommended miniature circuit breaker: 16 A characteristic B or 10 A characteristic C

Output

 

 

Output

Controlled, isolated DC voltage

Controlled, isolated DC voltage

Rated voltage Vout DC

24 V

24 V

Total tolerance, static ±

1 %

1 %

Static mains compensation, approx.

0.1 %

0.1 %

Static load balancing, approx.

0.1 %

0.1 %

Residual ripple peak-peak, max.

50 mV

50 mV

Spikes peak-peak, max. (bandwidth: 20 MHz)

150 mV

150 mV

Product function Output voltage adjustable

No

No

Status display

LED green for 24 V OK; LED red for error; LED yellow for stand-by

LED green for 24 V OK; LED red for error; LED yellow for stand-by

On/off behavior

No overshoot of Vout (soft start)

No overshoot of Vout (soft start)

Startup delay, max.

1.5 s

1.5 s

Voltage rise, typ.

10 ms

10 ms

Rated current value Iout rated

3 A

8 A

Current range

0 ... 3 A

0 ... 8 A

Active power supplied typical

72 W

192 W

Short-term overload current

 

 

  • ● on short-circuiting during the start-up typical

12 A

35 A

  • ● at short-circuit during operation typical

12 A

35 A

Duration of overloading capability for excess current

 

 

  • ● on short-circuiting during the start-up

70 ms

70 ms

  • ● at short-circuit during operation

70 ms

70 ms

Parallel switching for enhanced performance

Yes; Parallel switching of 3 A and 8 A possible, devices must be switched on at the same time, max. 75% per device with I-load

Yes; Parallel switching of 3 A and 8 A possible, devices must be switched on at the same time, max. 75% per device with I-load

Numbers of parallel switchable units for enhanced performance

2

2

Efficiency

 

 

Efficiency at Vout rated, Iout rated, approx.

87 %

90 %

Power loss at Vout rated, Iout rated, approx.

11 W

21 W

Closed-loop control

 

 

Dynamic mains compensation (Vin rated ±15 %), max.

0.1 %

0.1 %

Dynamic load smoothing (Iout: 50/100/50 %), Uout ± typ.

1 %

2 %

Dynamic load smoothing (Iout: 10/90/10 %), Uout ± typ.

3 %

3 %

Load step setting time 10 to 90%, typ.

5 ms

5 ms

Load step setting time 90 to 10%, typ.

5 ms

5 ms

Setting time maximum

5 ms

5 ms

Protection and monitoring

 

 

Output overvoltage protection

Additional control loop, limitation (closed loop control) at < 28.8 V

Additional control loop, limitation (closed loop control) at < 28.8 V

Current limitation

3.15 ... 3.6 A

8.4 ... 9.6 A

Current limitation, typ.

3.4 A

9 A

Property of the output Short-circuit proof

Yes

Yes

Short-circuit protection

Electronic shutdown, automatic restart

Electronic shutdown, automatic restart

Overload/short-circuit indicator

-

-

Safety

 

 

Primary/secondary isolation

Yes

Yes

Galvanic isolation

Safety extra-low output voltage Uout acc. to EN 60950-1 and EN 50178 and EN 61131-2

Safety extra-low output voltage Uout acc. to EN 60950-1 and EN 50178 and EN 61131-2

Protection class

Class I

Class I

Leakage current

 

 

  • ● maximum

3.5 mA

3.5 mA

  • ● typical

0.4 mA

1.3 mA

CE mark

Yes

Yes

UL/CSA approval

Yes

Yes

UL/cUL (CSA) approval

cULus-Listed (UL 508, CSA C22.2 No. 142), File E143289

cULus-Listed (UL 508, CSA C22.2 No. 142), File E143289

Explosion protection

ATEX (EX) II 3G Ex nA nC IIC T4 Gc; cULus (ISA 12.12.01, CSA C22.2 No.213) Class I, Div. 2, Group ABCD, T4, File E330455

ATEX (EX) II 3G Ex nA nC IIC T3 Gc; cULus (ISA 12.12.01, CSA C22.2 No.213) Class I, Div. 2, Group ABCD, T3, File E330455

Certificate of suitability IECEx

No

No

Certificate of suitability NEC Class 2

No

No

FM approval

Class I, Div. 2, Group ABCD, T4

Class I, Div. 2, Group ABCD, T4

CB approval

Yes

Yes

Marine approval

GL, DNV

GL, DNV

Degree of protection (EN 60529)

IP20

IP20

EMC

 

 

Emitted interference

EN 55022 Class B

EN 55022 Class B

Supply harmonics limitation

EN 61000-3-2

EN 61000-3-2

Noise immunity

EN 61000-6-2

EN 61000-6-2

Operating data

 

 

Ambient temperature

 

 

  • ● during operation

0 ... 60 °C

0 ... 60 °C

  • — Note

with natural convection

with natural convection

  • ● during transport

-40 ... +85 °C

-40 ... +85 °C

  • ● during storage

-40 ... +85 °C

-40 ... +85 °C

Humidity class according to EN 60721

Climate class 3K3, no condensation

Climate class 3K3, no condensation

Mechanics

 

 

Connection technology

Screw-/spring clamp connection

Screw-/spring clamp connection

Connections

 

 

  • ● Supply input

L, N, PE: 1 screw terminal each for 0.5 ... 2.5 mm²

L, N, PE: 1 screw terminal each for 0.5 ... 2.5 mm²

  • ● Output

L+, M: 2 spring-loaded terminals each for 0.5 to 2.5 mm²

L+, M: 2 spring-loaded terminals each for 0.5 to 2.5 mm²

Product function

 

 

  • ● removable terminal at input

Yes

Yes

  • ● removable terminal at output

Yes

Yes

Width of the enclosure

50 mm

75 mm

Height of the enclosure

147 mm

147 mm

Depth of the enclosure

129 mm

129 mm

Weight, approx.

0.45 kg

0.74 kg

Product property of the enclosure housing for side-by-side mounting

Yes

Yes

Installation

Can be mounted onto S7-1500 rail

Can be mounted onto S7-1500 rail

Other information

Specifications at rated input voltage and ambient temperature +25 °C (unless otherwise specified)

Specifications at rated input voltage and ambient temperature +25 °C (unless otherwise specified)


Дополнительно



Power connector

6ES7590-8AA00-0AA0

With coding element for power supply module; spare part,
10 units per packaging unit