SMC10 Sensor Module Cabinet-Mounted Siemens

Обзор



SMC10 Sensor Module Cabinet-Mounted

The SMC10 Sensor Module Cabinet-Mounted is required to evaluate the encoder signals of motors without a DRIVE‑CLiQ interface. External encoders can also be connected via the SMC10.

The following encoder signals can be evaluated:

  • 2-pole resolver
  • Multi-pole resolver

Дизайн



The SMC10 Sensor Module Cabinet-Mounted features the following connections and interfaces as standard:

  • 1 encoder connection including motor temperature detection (KTY84‑130 or PTC) via SUB‑D connector
  • 1 DRIVE-CLiQ interface
  • 1 connection for the electronics power supply via the 24 V DC power supply connector
  • 1 PE (protective earth) connection

The status of the SMC10 Sensor Module Cabinet-Mounted is indicated via a multi-color LED.

The SMC10 Sensor Module Cabinet-Mounted can be snapped onto a TH 35 standard mounting rail in accordance with EN 60715 (IEC 60715).

The signal cable shield is connected via the encoder system connector and can also be connected to the SMC10 Sensor Module Cabinet-Mounted via a shield connection terminal, e.g. Phoenix Contact type SK8 or Weidmüller type KLBÜ CO 1. The shield connection terminal must not be used for strain relief.

Интеграция



SMC10 Sensor Modules Cabinet-Mounted communicate with a Control Unit via DRIVE‑CLiQ.

Технические данные



SMC10 Sensor Module Cabinet‑Mounted

6SL3055-0AA00-5AA3

 

Power requirement, max.

at 24 V DC,
not taking encoder into account

0.2 A

  • Conductor cross-section, max.

2.5 mm2

  • Fuse protection, max.

20 A

Power loss, max.

10 W

Encoders which can be evaluated

  • 2-pole resolvers
  • Multi-pole resolver
  • Excitation voltage, rms

4.1 V

  • Excitation frequency

5 ... 10 kHz depending on the current controller clock cycle of the Motor Module or Power Module

  • Transformation ratio

0.5

  • Encoder frequency, max.

2 kHz (120000 rpm) depending on the number of resolver pole pairs and current controller clock cycle of the Motor Module or Power Module

  • Signal subdivision (interpolation), max.

16384 times (14 bit)

  • Cable length to encoder, max.

130 m (426 ft)

PE connection

M4 screw

Dimensions

 

  • Width

30 mm (1.18 in)

  • Height

150 mm (5.90 in)

  • Depth

111 mm (4.37 in)

Weight, approx.

0.4 kg (1 lb)

Approvals, according to

cULus