Tecsis — Press-In Sensor: Elongations from 0,1‰ ≤ e ≤ 0,25‰ F9303/F93C3
Наличие
Цена
Для уточнения цены нам необходимо связаться с производителем. Отправляйте запрос по почте, через корзину сайта или через форму заявки.
Ответим на Ваш запрос в течение 5 дней.
Доставка
- транспортной компанией на Ваш выбор
- самовывоз из офиса в Санкт-Петербурге
- бесплатная доставка до терминала “Деловые Линии” в Санкт-Петербурге
The press-in sensor has been developed for applications where deformations caused by external forces are to be measured in existing components. Due to the press-fit method, installation is simple and an existing component is given the properties of a force transducer.
The press-in sensor can be used in existing structures from a material thickness of 4 mm and a tensile strength of > 350 N/mm2. It issuitable for use in structures with a strain of 0,1‰ £ e £ 0,25‰. The press-in sensor contains an integrated programmable digital amplifier. After fitting the sensor, zero point and sensitivity are set using the tecsis handheld programming unit (EPE01). This makes a standardised mA or V signal available. Depending on the installation, an overall accuracy of < 2% F.S. scale range is achieved.
More information: Measuring with Pressed-in SensorsТехническая спецификация de944.pdf Инструкция по использованию be915.pdf
О компании Tecsis
Как производитель датчиков и измерительных приборов компания присутствует на рынке уже несколько десятилетий. К 1997г. она вышла на мировой рынок под эгидой бренда VDO, но уже в 2001 отделилась под собственным именем Tecsis.
Читать далее...